Saco Product Catalog

FACE FRAMES 3/4” thick kiln dried solid hardwood lumber. Bored, glued and screwed joint assembly. Stiles and rails are 1-1/2” in width and dadoed to receive sides, tops and bottoms. Mull are 3” wide. END PANELS 9mm (3/8”) thick plywood with laminated paper on both sides. Tops, bottoms and sides are dadoed into the face frame and recessed 3/16”. Dadoed to receive shelves, bottoms and tops. TOP/BOTTOM 9mm (3/8”) thick plywood with birch veneer on both sides. Let into ends and face frame. Bottoms are glued and stapled. Base cabinet floors are supported underneath at rear of cabinet by 9 mm (3/8”) plywood. HANGING RAILS Wall cabinets have 3/8” x 2-1/2” plywood strip running across the cabinet back at the top and bottom. Base cabinets have 3/8” x 3” plywood strip running across the top of the cabinet back. BACK PANEL Wall cabinets backs are 3/8” thick plywood with UV finish. Bases have 2.5mm (1/8”) plywood backs, finished with laminated paper, stapled to side panels and hanging rails. SHELVES 12 mm (1/2”) thick by 10-1/4” deep plywood edgebanded on front edge and finished with a clear coat. Wall shelves are adjustable. Base shelves are fixed; let into sides and glued. TOE BOARD 15 mm (5/8”) plywood. Mounted internally and extends from the bottom of the base floor to the bottom of the cabinet for full support. BASE CORNER BRACES High impact injection molded plastic. DRAWERS 12 mm (1/2”) plywood for sides, front and back of drawer box. Drawer box is dovetailed and glued. Drawer bottom is let into dadoed sides, front and back of box and glued. Bottom is 5.2 mm (1/4”) veneer plywood. Drawer is finished with a clear coat. DRAWER RAILS Epoxy coated steel side mounted self adjusting 75# load capacity rail system. Self closing, double captive rollers with built in stops. DOOR HINGES 6 way adjustable self closing heavy duty steel concealed hinge. Specifications