Celect Installation Handbook

• Measure for the starting panel of the second and remaining courses by measuring from the closest indexing mark to the corner (Fig. 9). • Measure and cut the panel so the right end of the panel will align with the indexing mark. • Fasten and complete the courses. Ÿ Measure for the starting panel of the second and remaining courses by m asuring from the closest indexing mark to the corner (Fig. 9) Ÿ Measure and cut the panel so the right end of the panel will align with the indexing mark. Ÿ Fasten and complete the courses. Ÿ Measure for the starting panel of the second and r maining courses by measuring from the closest indexing mark to the corner (Fig. 9) Ÿ Measure and cut the panel so the right end of the panel will align with the indexing mark. Ÿ Fasten and complete the courses.

Indexing Mark Indexing Mark

Fig. 11 Fig. 11

Gables • The same 3/8” gap should be left in gable areas or anywhere the ends of the panels terminate (Fig. 7). Either Trim Board, Finish Trim or Gable Trim (Fig. 8,9) can be used. GABLES Ÿ The same 3/8” gap should be left in gable areas or anywhere the ends of the panels terminate (Fig.7).Either Trim Board, Finish Trim or Gable Trim (Fig. 8.9) can be used. GABLES Ÿ The same 3/8” gap should be left in gable areas or anywhere the ends of the panels terminate (Fig.7).Either Trim Board, Finish Trim or Gable Trim (Fig. 8.9) can be used.

Fig. 7 Fig. 7

Furring

3/8” gap

Furring

Trim Board

3/8” gap

Trim Board

42 42 42